说明

public function Imagick::resizeImage(
    int $columns,
    int $rows,
    int $filter,
    float $blur,
    bool $bestfit = false,
    bool $legacy = false
): bool

Scales an image to the desired dimensions with a filter.

注意:
参数 bestfit 的特性在 Imagick 3.0.0 中已改变。在此版本以前，当目标尺寸设为 400x400 时，原尺寸为 200x150 的图像将不会被改变。自 Imagick 3.0.0 起，源图像将会被放大到 400x300 因为这将更好的适合目标尺寸。当使用参数 bestfit 时，必须同时给出宽度和高度。

参数

columns: Width of the image
rows: Height of the image
filter: Refer to the list of filter constants.
blur: The blur factor where > 1 is blurry, < 1 is sharp.
bestfit: Optional bool parameter. If set to true, the image is resized to fit within the given dimensions while preserving the aspect ratio.
legacy: Optional bool parameter. If set to true, the calculations are done with the small rounding bug that existed in Imagick before 3.4.0. If set to false, the calculations should produce the same results as the ImageMagick command-line tools.

返回值

成功时返回 true。

更新日志

版本	说明
PECL imagick 2.1.0	Added optional fit parameter. This method now supports proportional scaling. Pass zero as either parameter for proportional scaling.
PECL imagick 3.4.0	Added the `legacy` parameter.

示例

示例 #1 Imagick::resizeImage()

<?php
function resizeImage($imagePath, $width, $height, $filterType, $blur, $bestFit, $cropZoom) {
    //The blur factor where > 1 is blurry, < 1 is sharp.
    $imagick = new \Imagick(realpath($imagePath));

    $imagick->resizeImage($width, $height, $filterType, $blur, $bestFit);

    $cropWidth = $imagick->getImageWidth();
    $cropHeight = $imagick->getImageHeight();

    if ($cropZoom) {
        $newWidth = $cropWidth / 2;
        $newHeight = $cropHeight / 2;

        $imagick->cropimage(
            $newWidth,
            $newHeight,
            ($cropWidth - $newWidth) / 2,
            ($cropHeight - $newHeight) / 2
        );

        $imagick->scaleimage(
            $imagick->getImageWidth() * 4,
            $imagick->getImageHeight() * 4
        );
    }


    header("Content-Type: image/jpg");
    echo $imagick->getImageBlob();
}

?>